3D Vision Blog - Forum

Acer X1261P and nVidia 3D wizard..
Page 1 of 1

Author:  TheNephilim [ 20 Nov 2013, 07:35 ]
Post subject:  Acer X1261P and nVidia 3D wizard..

Hey all,

I am hoping someone here is knowledgeable and can offer me a solution to my unique problem..

The Acerx1261P native resolution is 1024x768 and with the the total res is 3072x768. Now I ran into my problem when I ran the 3D wizard, it appeared to have went into a higher resolution then the projector is capable of and fried my DVI Port or something..

Now I am trying to figure out how to keep the wizard from going into such a High resolution.. I know it did because I hooked up a LCD Monitor to it and the res was at 1920x1080.. and since the native res and the most this DLP Projector can do is 1440, I need to figure out How to make the wizard run in my Projectors Native resolution not 1920x1080??

Why does it do that, I thought it was supposed to run at the monitors native rez and not a preset res??

Author:  Bloody [ 26 Nov 2013, 13:58 ]
Post subject:  Re: Acer X1261P and nVidia 3D wizard..

You need to go through the 3D wizard only the first time when you enable the stereoscopic 3D mode, then you can switch on and off the stereoscopic 3D support from the Nvidia Control Panel. The simples solution is just to edit the registry key to enable the stereoscopic 3D mode directly without having to go through the 3D setup wizard at all.

Author:  TheNephilim [ 26 Nov 2013, 20:31 ]
Post subject:  Re: Acer X1261P and nVidia 3D wizard..

Hi Bloody, Yes I found the registry mod and will use that from know on thnx..

Page 1 of 1 All times are UTC + 2 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group